Align Solutions

This application shows curved panels suspended from the ceiling using Cable hardware with the 1” Top Gripper that are then joined using the Align hardware.

There are various ways to capture panels at the top and bottom. In this solution the panels are captured in the space between an MDF template, but panels could be captured by a U-channel, cable hardware, thru-holes with standard bolts, etc. However, most resin materials are inherently slightly flexible or have some gauge variance. The Align hardware is used to bring these panels together and create a clean installation with a very minimal reveal. This allows installations to be accomplished without gluing on the job site. 3form Align hardware can work with a radius as small as 24” on curved panels

Partitions can be created using cables or surface brackets at the top, and surface brackets at the bottom. This particular application uses Fixed Surface Brackets on the top and bottom with thru-holes to hold the panel secure. The panels are then joined with the Align Smooth hardware. This is done in this application with complex-formed panels that have flat vertical edges.